Cellular Automaton

Planting two-phase Seed : You can plant only TWO seeds.

You can see how the waves propagate and go over an obstacle in the middle of the field.

Please follow the steps below.

Step 1. Please enter the Number of state to any number between 30 and 45 to see better result,

then press Set numStates button.

Step 2. Please enter the Number of seed to the number 2 only, then press Set numSeeds button.

Step 3. Once seed coordinate windows are shown, please enter the coordinate (integer only) of 1^st seed,

then press Set coordinate button. Finish entering the coordinate of all seeds.

Note : 1. Every time you enter the coordinate of a seed, you must press the Set coordinate button

next to the coordinate that you entered.

2. Once you press the last Set coordinate button, it will take a while to configure the applet.

3. Please be patient. : )

Step 4. Please press Start button twice to run the simulation