10.1 Modelling Discrete Sequences

 

Building HMMs for discrete symbol sequences is essentially the same as described previously for continuous density systems. Firstly, a prototype HMM definition must be specified in order to fix the model topology. For example, the following is a 3 state ergodic HMM in which the emitting states are fully connected.

    ~o <DISCRETE> <StreamInfo> 1 1 
    ~h "dproto"
    <BeginHMM>
       <NumStates> 5 
       <State> 2 <NumMixes> 10
          <DProb> 5461*10
       <State> 3 <NumMixes> 10
          <DProb> 5461*10
       <State> 4 <NumMixes> 10
          <DProb> 5461*10
       <TransP> 5
           0.0 1.0 0.0 0.0 0.0
           0.0 0.3 0.3 0.3 0.1
           0.0 0.3 0.3 0.3 0.1
           0.0 0.3 0.3 0.3 0.1
           0.0 0.0 0.0 0.0 0.0
    <EndHMM>

As described in chapter 7, the notation for discrete HMMs borrows heavily on that used for continuous density models by equating mixture components with symbol indices. Thus, this definition assumes that each training data sequence contains a single stream of symbols indexed from 1 to 10. In this example, all symbols in each state have been set to be equally likely. If prior information is available then this can of course be used to set these initial values.

The training data needed to build a discrete HMM can take one of two forms. It can either be discrete (SOURCEKIND=DISCRETE) in which case it consists of a sequence of 2-byte integer symbol indices. Alternatively, it can consist of continuous parameter vectors with an associated VQ codebook. This latter case is dealt with in the next section. Here it will be assumed that the data is symbolic and that it is therefore stored in discrete form.  Given a set of training files listed in the script file train.scp, an initial HMM could be estimated using

    HInit -T 1 -w 1.0 -o dhmm -S train.scp -M hmm0 dproto

This use of HINIT is identical to that which would be used for building whole word HMMs where no associated label file is assumed and the whole of each training sequence is used to estimate the HMM parameters. Its effect is to read in the prototype stored in the file dproto and then use the training examples to estimate initial values for the output distributions and transition probabilities. This is done by firstly uniformly segmenting the data and for each segment counting the number of occurrences of each symbol. These counts are then normalised to provide output distributions for each state. HINIT then uses the Viterbi algorithm to resegment the data and recompute the parameters. This is repeated until convergence is achieved or an upper limit on the iteration count is reached. The transition probabilities at each step are estimated simply by counting the number of times that each transition is made in the Viterbi alignments and normalising. The final model is renamed dhmm and stored in the directory hmm0.

When building discrete HMMs, it is important to floor the discrete probabilites so that no symbol has a zero probability. This is achieved using the -w option which specifies a floor value as a multiple of a global constant called MINMIX whose value is .

The initialised HMM created by HINIT can then be further refined if desired by using HREST to perform Baum-Welch re-estimation. It would be invoked in a similar way to the above except that there is now no need to rename the model. For example,

    HRest -T 1 -w 1.0 -S train.scp -M hmm1 hmm0/dhmm

would read in the model stored in hmm0/dhmm and write out a new model of the same name to the directory hmm1.